wholesale fc1501 uses the bending deformation properties of materials to work with the torsional deformation of materials. In order to allow more people to understand the inertia problems and reasons of the catapult machine more comprehensively, the railway switch manufacturers will briefly introduce the inertia problems and reasons of the catapult machine.
wholesale fc1501 uses the bending deformation properties of materials to work with the torsional deformation of materials. In order to allow more people to understand the inertia problems and reasons of the catapult machine more comprehensively, the railway switch manufacturers will briefly introduce the inertia problems and reasons of the catapult machine.
1. If the popup window is not installed correctly, the distance between the popup window on the inside of the small lake and the embedded iron stone end is 8-10 mm, which can not be too tight or too far. Otherwise, it will affect the clamping, residual deformation and service life of the popup window.
2. Hammer the loading and unloading of the magazine. When installing the magazine, use special tools to properly install it. Hammering with the hammer will deform the magazine and damage the magazine.
3, metal parts coating damage, corrosion. There is no protection during transportation, loading and unloading, or repeated decomposition wear, friction machine, contact with other mechanical damage during installation. Recommend the work of civilization. Paint and oil should be applied to the rusty parts in time.
4. The rod installation torque is too large, and the rod is fixed to the front jaw in the middle of the rod and the insulation gauge block are just in contact, and the interval is less than 0.5mm. When the installation torque is too large, the gauge block is pressed into the pit and deformed, the size deformation is displayed outside the window, the residual deformation is too much, and the pressure of the pop-up buckle is reduced when the installation is in place, and the fatigue life is shortened. If the magazine and gauge block are damaged, they should be replaced immediately.
5. The spacing between the leading edge of the pop-up window and the insulation block is greater than 0.5mm, the installation torque is small, and the buckle pressure of the pop-up window fastener is small, which affects the safety of the line. To twist again at the three point contact of the popup.
In fact, there is a lot of information about wholesale fc1501 and various problems with its use. In order not to affect normal use, it must be handled in time to make the line safe. When using wholesale fc1501, if you encounter the above problems, please refer to the provided method to explain. When using wholesale fc1501, if other conditions occur, you can seek expert treatment to avoid greater damage.
wholesale fc1501 https://www.hbrailwayfastening.com/Tunnel-Bridge-Fastenings
Comments (0)